Ubiquiti NanoStation M2 MIMO Wireless Bridge/Base Station description

• Connect two remote locations on the one network
• Share Internet connection between buildings, remote sites, etc.
• Up to 600mW output power, 2×2 MIMO operation, 150Mbps
• Integrated AirOS web software for controlling power, bridge/AP mode, etc.
• Includes PoE injector and 240V AC adaptor
• Two units are required for the wireless bridge
• High-speed point-to-point networking.

Usage

• Forget Ethernet cable, the Ubiquiti NanoStation is ideal for bridging networks or sharing broadband across distance
• To install, place the units at either end of the network and connect both to Ethernet cables – for example, connect the first unit to your modem at location one, and connect the second to an Ethernet switch or WiFi access point at the other location
• Up to six remote buildings can be linked over one connection with the NanoBridge supporting AP-WDS.

• This is a transparent data-link layer bridge, not a routed bridge – this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple – no routing configuration, all protocols (DHCP, DNS, etc) just work
• Management of the Ubiquiti device couldn’t be easier with SSH and SNMP protocol support and an intuitive HTTP interface.

802.11b/g/n WiFi Access Point

• Login to the AirOS management software and set it to AP mode to create a high-performance, long-range WiFi network
• With a wide directional broadcast angle, the NanoStation M2 is ideal for covering sports grounds and outdoor areas with a sector-by-sector approach
• You can learn how to set up the NanoStation as a long-range WiFi access point by following their Quick Start Installation Manual

Ready to Install

• This unit has all networking hardware integrated and is completely weatherproof for permanent installation in even the toughest environments
• Signal strength indicators allow for quick and easy alignment
• For best performance, mount the unit on the roof, high and clear of obstructions, using its integrated pole mounting bracket.
• Power the units via Power over Ethernet (PoE) by plugging one end of the Ethernet cable into the NanoStation and the other into the PoE Injector, which connects to AC power. This setup allows the cable to both power the unit and carry network traffic.
• We recommend using Cat6 Outdoor UV Shielded Cable with this unit.

 

A heads Up

 

• Surge protection should be used for all outdoor installations. Ubiquiti recommends that you use two Ethernet Surge Protectors – model ETH-SP – place one near the NanoStation and the other at the entry point to the building
• The ETH-SP will absorb power surges and safely discharge them into the ground.

Also see;

Ubiquiti airFiber 5X Antenna AF-5G23-S45

The Ubiquiti airFiber 5X Antenna AF-5G30-S45

Ubiquiti airFiber 5X Antenna AF-5G34-S45